Roof Panel — Porsche 911 / 912 (JP-1940-0)

Stop rust in its tracks. This JP Group full roof panel is a direct, weld-in replacement for the Porsche 911/912's original steel panel — built to the factory profile so your restoration or rust-repair goes back together the way it left the factory.

Vehicle Fitment

• 1965–1973 Porsche 911; 1965–1969 Porsche 912

Key Features & Benefits

• Stamped from steel to match the original factory panel profile for accurate, weld-in fitment
• Bare steel finish — ready for weld-in installation, seam sealing, epoxy primer, and paint
• Eliminates the need to fabricate a repair section by hand or source hard-to-find used sheet metal
• Manufactured by JP Group (Denmark), a long-established supplier of classic Porsche restoration sheet metal

Technical Specifications

• Part #: JP-1940-0 · Interchange/OEM ref: 1682001000
• Material: Stamped steel
• Country of Origin: Denmark
• Condition: New, aftermarket reproduction
• Approximate shipping dimensions: 60 x 52 x 10 in (L x W x H), 45 lb

Frequently Asked Questions

What material is this panel made from?
Stamped steel, supplied bare and ready for weld-in installation, seam sealing, and paint.

Is this a genuine Porsche part or an aftermarket reproduction?
This is an aftermarket reproduction manufactured by JP Group of Denmark, built to match the factory panel's fit and profile — it is not a genuine Porsche OEM part.

Does it require welding to install?
Yes. This is a weld-in restoration panel intended for installation by a qualified body shop or experienced fabricator using standard MIG or spot-welding techniques.

⚠ WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.